![]() ![]() +/-: The +/- options activate an additional prompt that allows you to plot line segments at a 90 degree deflection angle from the last line. This command is similar to the polyline command described above with the following additions: This command allows you to draw a 2D Polyline. The minimum radius length is given to you. First you pick the arc end point and then you can enter the radius length. Rad : Allows you to specify a radius length. ![]() Sec : Allows you to specify the second point and end point to define the arc. First you pick the arc end point and then you can enter the arc length. Len : Allows you to specify the arc length. After picking the center point, you must specify the arc end point and then the arc direction. You have various options for constructing an arc as part of your polyline.ĬEn : Allows you to specify the center point (or radius point) for the arc. See below for details.Ĭ : Closes the polyline (you must have at least two polyline segments drawn before you can close)Īfter choosing A, the command line will change to: The default option is to keep picking points and the other options are described below.Ī : Starts an arc segment. ![]() First, pick your starting point then you have several options on the command line. You can pick points from the screen or type in point numbers. This command allows you to draw a polyline between points. Below you will find each feature described. The Draw menu is found next to the View menu in MAP view. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |